Micro-Aide LDM-1 Manuale Utente Scaricare il pdf (Pagina 17)

Setup and Installation - Network Types

• The RTS signal of the master modem can be permanently asserted. Refer to

the section entitled “Permanently Asserting the RTS” on page 15.

• RTS-CTS flow control must be used by each DTE device connected to a

slave modem.

• The near- to far-end cable length must not exceed the recommendations as

listed in Table 5 on page 30 for the given cable size and selected Baud rate.

• The Equalization setting for the near- and far-end modems must be identical

and set in accordance with the recommendations as listed in Table 6 on

page 31. Assume a cable length equal to the near-end to far-end cable length.

• The Equalization setting for a drop point modem must also be set in accor-

dance with the recommendations as listed in Table 6 on page 31. Assume a

cable length equal to the length between the near-end modem (i.e., master)

and the drop point modem.

Figure 4 - Typical Multi-Drop Network

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Nessun commento

Micro-Aide LDM-1 Manuale Utente Pagina 17